How to Install an Extra Panel on Your S-NANO V2: Step-by-Step Upgrade Guide

The S-NANO V2 is a favorite among EDC enthusiasts for its compact design and modular freedom. One of the best ways to personalize your tool is by adding an extra panel that changes its look or function. The Extra Panel for S-NANO V2 is designed to swap easily, but doing it right the first time avoids scratches and loose-fitting edges.

This guide walks you through the entire install from what you need to final inspection. Whether it’s your first mod or you’re just looking for a cleaner routine, these steps work with precision and without any special tools.

What You'll Need Before Starting

Before you touch your tool, gather the small basics: a clean, flat workspace, a microfiber cloth, and your S-NANO V2. The Extra Panel for S-NANO V2 is designed as a direct drop-in, so you won’t need any tiny screwdrivers or aftermarket glue – that’s a big reason why it’s a favorite upgrade for quick changes.

One thing that helps is a soft, non-abrasive surface. A desk mat or even a folded cloth works. Titanium surfaces resist most scratches, but dropping the panel during install on hard stone can still leave a subtle sign, which is avoidable with a two-second setup.

• Work on a lint, silk, cloth – avoid paper towels that can scratch
• Check the new panel’s edges for any debris or burrs before fitting

Step 1 – Remove the Existing Panel

Hold your S-NANO V2 firmly by the main body, with the existing panel facing up. Most panels press into place with a light spring or magnetic tension, so frame your thumb on the panel’s edge and apply slow, even pressure toward . Do not pry with a blade or screwdriver, as that can mar the aluminum, no matter how urgent it feels.

If the panel feels stuck anywhere, rotate it slightly side-to-side rather than forcing it. It’s common for panels to sit tight if they’ve been locked in for weeks. A quarter-turn usually breaks the vacuum and lets it lift cleanly.

• Pulling straight up rarely works – tilt the panel slightly as you lift
• If resistance stays, a simple rubber band wrapped around the edge adds grip without scratches

3 – Fix the New Extra Panel in Place

Turn the new Extra Panel for S-NANO V2 so the write/back face matches your SUL's orientation – it should fit absolutely flat against the host and the holes should line up perfectly with the body pins. Lower it evenly onto the mating surface, pressing from the center outward so the whole width bots in smoothly.

You should feel a soft seat click when it’s fully seated. If the edges don’t look flush, lift it and re-align after inspecting for a stray dust fragment. Most guideline invitations happen because the panel was positioned at a slight angle, not because the fit is wrong.

• Avoid dipping any side in first – even pressure from the middle wins
• Your panel sits perfectly if you can’t fit a fingernail between the layers

Check and Break – In Care Tips

Once the panel is on, give the tool a quick flex in your hand. A correct seat stays perfectly rigid, and any click is a sign you should reseat., a brand-new panel might feel slightly stiff in the first week, which is normal as the machining surfaces settle together.

For routine care, wipe the extra panel with themicrofiber cloth to clean smudges—nothing harsh is needed. The titanium nature of the pendant stays naturally hypoallergenic and resist corrosion. If you ever swap back to the original panel, keep the spare in a soft pouch or the same cloth storage to prevent any edge signs.

bullets

Install an extra panel on your S-NET-V2 is a rewarding way to change your carry on a budget, and the whole process should take under a couple of minutes. Once you get the hang of the alignment and the click, panel swaps become as ordinary as changing a keychain component. Keep a microfiber cloth nearby and your S-NANO panels will stay looking crisp project after project.